您的位置: 标准下载 » 国内标准 » GB 国标 »

GB/T 3048.12-2007 电线电缆电性能试验方法 第12部分:局部放电试验

时间:2024-05-22 11:06:53 来源: 标准资料网 作者:标准资料网 阅读:9940
下载地址: 点击此处下载
基本信息
标准名称:电线电缆电性能试验方法 第12部分:局部放电试验
英文名称:Test methods for electrical properties of electric cables and wires—Part 12:Partial discharge test
中标分类: 电工 >> 电工材料和通用零件 >> 电缆及其附件
ICS分类: 电气工程 >> 电线和电缆
替代情况:替代GB/T 3048.12-1994
发布部门:中华人民共和国国家质量监督检验检疫总局 中国国家标准化管理委员会
发布日期:1983-01-01
实施日期:2008-05-01
首发日期:1983-11-24
作废日期:
主管部门:中国电器工业协会
提出单位:中国电器工业协会
归口单位:全国电线电缆标准化技术委员会
起草单位:上海电缆所
起草人:万树德、余震明、夏凯荣、张兆焕、范作义
出版社:中国标准出版社
出版日期:2008-05-01
页数:20页
计划单号:20021304-T-604
适用范围

本标准规定了局部放电试验的术语和定义、试样设备、试样制备、试验程序、试验结果及计算、注意事项、试验设备的校准和试验记录。

前言

没有内容

目录

前言Ⅰ 1 范围1 2 规范性引用文件1 3 术语和定义1 4 试验设备1 5 试样制备6 6 试验程序6 7 注意事项8 8 试验设备的校准8 9 试验记录9 附录A (资料性附录) 本部分章条编号与IEC60885-3:1988章条编号对照10 附录B (规范性附录) 双脉冲曲线绘制方法11 附录C (规范性附录) 终端阻抗的要求13 C.1 终端阻抗的构成13 C.2 RC 元件13 C.3 RLC 元件(串联谐振线路) 13 附录D (资料性附录) 全屏蔽局部放电测试系统技术条件14 D.1 独立的供电电源14 D.2 电源的滤波系统14 D.3 隔离地坪14 D.4 全屏蔽室14 D.5 试验设备和测试仪器14 D.6 注意事项14

引用标准

没有内容

所属分类: 电工 电工材料和通用零件 电缆及其附件 电气工程 电线和电缆
【英文标准名称】:Imagerecordingsystemconsistingofaradiographicfilm,intensifyingscreensandafilmcassetteforuseinmedicaldiagnostics;evaluationofspeedandaveragegradient
【原文标准名称】:X光医疗诊断用.由X光胶片.增感膜和暗盒组成的图象记录系统.感光度和平均灰度测定
【标准号】:DIN6867T.1-1985
【标准状态】:作废
【国别】:
【发布日期】:
【实施或试行日期】:
【发布单位】:德国标准化学会(DE-DIN)
【起草单位】:
【标准类型】:()
【标准水平】:()
【中文主题词】:
【英文主题词】:
【摘要】:
【中国标准分类号】:C43
【国际标准分类号】:
【页数】:
【正文语种】:


Product Code:SAE J2014
Title:Pneumatic Tires for Military Tactical Wheeled Vehicles
Issuing Committee:Truck And Bus Military Industry Tire Task Force
Scope: This SAE Recommended Practice applies to all combinations of pneumatic tires for military tactical wheeled vehicles only as defined in SAE J2013. This applies to original equipment and new replacement tires and the retread of these tires. This document describes tests, test methodology, and certain minimum requirements to evaluate and measure tire and tire-vehicle related performance. The mission profile of the vehicle determines which of these tests are required and should be selected. Therefore, all of the tests included in this document are not required for each tire. The tire technical activity for the vehicle system has the responsibility for the selection of a specific test(s) to be used. The selected test(s) should be limited to that required to evaluate the tire or tire-vehicle characteristic which is related to the desired vehicle performance. Selected requirements of this specification shall be used as the basis for procurement of tires for military tactical wheeled vehicles. related to the desired vehicle performance. Selected requirements of this specification shall be used as the basis for procurement of tires for military tactical wheeled vehicles.